Accessories for Honda Goldwing® Helmet Headsets

Permanent installation of the 5-pin DIN panel jacks provides the look of a high-quality manufacturer's original equipment and protects the communication cables from excessive stress. The socket is installed either in the trim or in the rear of the seat, however a 12V on-board socket can also be replaced by the installation socket.
The 5-pin wires plus shielding are connected through 1:1, whereby the DIN plug connections and cable wires are compatible with all 5-pin communication and connection cables.

The plain connection cable provides excellent qualitative performance features for the use of communication  of Honda GoldWing® Headsets on Honda GoldWing® Radios and is available in lengths of 60cm, 120cm and 180cm.

The connection cable, which was specially manufactured for the communication use of Honda GoldWing® Headsets on Honda GoldWing® Radios, provides excellent quality performance characteristics

The interference filter serves to suppress radio interference caused by the ignition system, alternator, motronic/CDI, ABS, etc., which is picked up via a 12V power supply line and transmitted to the communication control unit.

This electronic high performance interference filter serves to suppress substantial interference caused by the ignition system, alternator, motronic/CDI, ABS, etc., which is picked up via a 12V power supply line and transmitted to the communication control unit.

The windshield foam caps, also known as "socks", reduce the microphone ambient noise by approximately 12dB, thus providing improved voice quality when using gooseneck microphone systems in open face helmet mode resp. when the chin section of a flip-up and system helmet is folded up.

The foam cap is simply placed over the microphone and secured against loss with the included foam tape.